Speed limit, Stopwatch – BMW 525xi Sedan 2006 User Manual
Page 83
81
The symbols also indicate the status of the ser-
vice requirements display, refer to page
.
Displays after completion of trip
Malfunction reports generated during the trip
are shown consecutively when you switch off
the ignition.
Before the display disappears, you can display
the messages once again. Press the CHECK
button for approx. 2 seconds. If several mes-
sages are present, you can continue to press
the CHECK button to view them in succession.
The display goes out
>
automatically after a brief period
>
when you press the CHECK button again
for approximately 2 seconds
Speed limit
You can enter a speed and a Check Control
message indicates when you have reached this
speed. This enables you, for example, to
receive warnings if you exceed a speed limit in
an urban area.
You are only warned of reaching this speed a
second time if your vehicle speed falls below it
again by at least 3 mph/5 km/h.
Displaying, setting or changing limit
iDrive, for explanation of principle, refer to
page
1.
Open the start menu.
2.
Open "Navigation".
Without navigation system
*
:
Open "Car Data".
3.
Select "Car Data" and press the controller.
4.
Select "Limit" and press the controller.
5.
Select the speed value and press the con-
troller.
6.
Turn the controller to set the limit. If
needed, hold it against a slight resistance
to enter a larger difference.
7.
Press the controller to apply the setting.
The limit is automatically activated.
Applying your current speed as limit
Select "Select current speed" and press the
controller. The system adopts your current
speed as the limit.
Activating limit
Select "On" and press the controller.
Limit is automatically activated.
Stopwatch
iDrive, for explanation of principle, refer to
page
.
1.
Open the start menu.
2.
Open "Navigation".
Without navigation system
*
:
Open "Car Data".
3.
Select "Car Data" and press the controller.
Online Edition for Part No. 01 41 0 012 211 - © 02/06 BMW AG