beautypg.com

BMW M6 Convertible 2008 User Manual

Page 221

background image

M

o

bi

lity

219

Re

fe

re

n

c

e

At

a

g

la

n

c

e

Co

n

tr

o

ls

D

riv

in

g ti

ps

C

o

m

m

uni

ca

ti

o

n

s

Na

v

iga

ti

on

En

te

rt

a

in

m

e

n

t

Model with pressure gauge integrated
in housing*

3 Connector and cable for lighter socket
4 Mounting for sealing bottle
5 Compressor
6 On/Off switch
7 Pressure gauge for indicating tire inflation

pressure

8 Button for reducing tire inflation pressure
9 Connecting hose for connecting compres-

sor and sealant bottle or compressor and
wheel

Connector, cable and connecting hose are
stored on underside of compressor.

Using M Mobility System

To repair a flat tire with the M Mobility System,
proceed as follows:

>

Fill sealant into wheel, refer to page

219

.

>

Distribute sealant, refer to page

219

.

>

Produce tire inflation pressure, refer to
page

219

.

Filling sealant into wheel

Strictly comply with the specified order,
otherwise highly pressurized sealant

could escape.

<

1.

Shake sealant bottle.

2.

Screw hose

9 onto connection of sealant

bottle.

3.

For model with pressure gauge on hose:
Make sure that screw

8 on pressure gauge

is closed.

4.

Screw dust cap off valve of defective wheel
and screw filling hose

2 of sealant bottle

onto valve.

5.

Insert sealant bottle on compressor hous-
ing so that it is positioned upright.

6.

Make sure that device is switched off,
position 0.

7.

Insert connector

3 into lighter socket in

vehicle interior, refer to page

112

.

8.

With the ignition switched on, refer to
page

59

:

Switch on the device and allow to run for
approx. 3 minutes to fill wheel with sealant.
It is not important what inflation pressure
the tire has after filling.

9.

Switch off device.

10.

Remove connecting hose from connection
of sealant bottle and tire valve.
Stow the M Mobility System in the vehicle
again.

Distributing sealant

Immediately drive approx. 2 miles/3 km so that
sealant is evenly distributed in tire.

Do not exceed a maximum speed of
35 mph/60 km/h. Do not drop below

12 mph/20 km/h if possible.

<

Producing tire inflation pressure

1.

After approx. 2 miles/3 km, stop at suitable
location.

2.

Screw compressor hose

9 directly onto tire

valve.

3.

Insert connector

3 in lighter socket in vehi-

cle interior.

Online Edition for Part no. 01 41 0 014 244 - © 08/07 BMW AG

This manual is related to the following products: