BMW Z4 sDrive35i 2010 User Manual
Page 205
203
2.
Press button
2 in the turn indicator lever.
The oil level is checked and the reading dis-
played.
Possible displays
1 Oil level OK
2 Oil level is being checked.
This can take about 3 minutes if the car is at
a standstill on a level surface, or about
5 minutes while the car is on the move.
3 Oil level down to minimum:
Add engine oil as soon as possible, but no
more than 1 US quart/1 liter, refer also to
Adding engine oil on page
4 Oil level is too high.
Too much oil will harm the engine.
Have the vehicle checked without
delay.
<
5 The oil level sensor is defective.
Do not add engine oil. You can continue
your journey. Note the newly calculated dis-
tance remaining to the next oil service, refer
to page
. Have the system checked as
soon as possible.
Display via iDrive
1.
"Vehicle Info"
2.
"Vehicle status"
3.
"Engine oil level"
Possible messages
>
"Engine oil level OK"
>
"Measurement not possible at this time."
>
"Measuring engine oil level...":
This can take about 3 minutes if the car is at
a standstill on a level surface and the engine
is running, and about 5 minutes while the
car is moving.
If engine oil was added, it may take up to
30 minutes to obtain an oil level reading.
>
"Engine oil level below minimum. Add 1
quart!"
Add engine oil as soon as possible, but no
more than 1 US quart/1 liter, refer also to
Adding engine oil below.
>
"Engine oil level too high! Have this
checked."
Too much oil will harm the engine.
Have the vehicle checked without
delay.
<
Online Edition for Part no. 01 41 2 602 883 - © 08/09 BMW AG