beautypg.com

Practical interior accessories, Integrated universal remote control – BMW Z4 sDrive35i 2010 User Manual

Page 102

background image

Practical interior accessories

100

Practical interior accessories

Integrated universal remote

control*

The concept

The integrated universal remote control can
replace as many as three hand-held transmit-
ters for various remote-controlled devices,
such as garage doors and gates or lighting sys-
tems. The integrated universal remote control
registers and stores signals from the original
hand-held transmitters.
The signal of an original hand-held transmitter
can be programmed on one of the three mem-
ory buttons

1. After this, the programmed

memory button

1 will operate the system in

question. The LED

2 flashes to confirm trans-

mission of the signal.
Should you sell your vehicle one day, be sure to
delete the stored programs beforehand for your
safety, refer to page

101

.

To prevent possible damage or injury,
before programming or using the inte-

grated universal remote control, always inspect
the immediate area to make certain that no peo-
ple, animals or objects are within the pivoting or
travel range of the device being operated. Com-
ply also with the safety instructions supplied
with the original hand-held transmitter.

<

Checking compatibility

If this symbol appears on the package
or in the instructions supplied with the
original hand-held transmitter, you can

assume that the radio remote control device will
be compatible with the integrated universal
remote control.

For additional information, please contact your
BMW center or call: 1-800-355-3515.
You can also obtain information on the
Internet at:
www.bmwusa.com or
www.homelink.com.
HomeLink is a registered trademark of Johnson
Controls, Inc.

<

Programming

1 Memory buttons
2 LED

Fixed-code hand-held transmitters

1.

Switch on the ignition, refer to page

50

.

2.

When starting operation for the first time:
press the left and right memory buttons

1

for approx. 20 seconds until the LED

2

flashes rapidly. The three memory buttons
are cleared.

3.

Hold the original hand-held transmitter at a
distance of approx. 4 to 12 in/10 to 30 cm
from the memory buttons

1.

The required distance between the
hand-held transmitter and the mem-

ory buttons

1 depends on the system of

the respective original hand-held transmit-
ter used.

<

Online Edition for Part no. 01 41 2 602 883 - © 08/09 BMW AG

This manual is related to the following products: