Care, Car washes – BMW Z4 sDrive35is 2011 User Manual
Page 215
Care
Car washes
Notes
Steam jets or high-pressure washers
When using steam jets or high-pressure
washers, hold them a sufficient distance away
and use a maximum temperature of 140 ℉/
60 ℃.
Holding them too close or using excessively
high pressures or temperatures can cause dam‐
age or preliminary damage that may then lead to
long-term damage.
Follow the operating instructions for the high-
pressure washer.◀
Cleaning sensors/cameras with high-
pressure washers
When using high-pressure washers, do not
spray the seals of the retractable hardtop and
the exterior sensors and cameras, for Park Dis‐
tance Control*, for instance, for extended peri‐
ods of time and only from a distance of at least
12 in/30 cm.◀
Wash your vehicle frequently, particularly in win‐
ter.
Intense soiling and road salt can damage the ve‐
hicle.
Washing in automatic car washes
Your vehicle can be washed in automatic car
washes right from the start.
Give preference to cloth car washes or those
that use soft brushes in order to avoid paint
damage.
Notes
Note the following:
▷
Make sure that the wheels and tires are not
damaged by the transport mechanisms.
▷
Fold in the exterior mirrors; otherwise, they
may be damaged, depending on the width of
the vehicle.
▷ Deactivate the rain sensor, refer to
to avoid unintentional wiper acti‐
vation.
▷
Unscrew the road antenna*.
Guide rails in car washes
Avoid car washes with guide rails higher
than 4 in/10 cm; otherwise, the vehicle body
could be damaged.◀
Before driving into a car wash
The vehicle is able to roll if the following steps
are taken.
Manual transmission
1.
Shift to neutral.
2. Release the parking brake, refer to
3.
Switch the engine off.
Automatic transmission*
1.
Insert the remote control into the ignition
lock, even with Comfort Access.
2.
Move the selector lever to position N.
3. Release the parking brake, refer to
4.
Switch the engine off.
5.
Leave the remote control in the ignition lock
so that the vehicle can roll.
7-gear sport automatic transmission with
dual clutch*
1.
Insert the remote control into the ignition
lock, even with Comfort Access.
2.
Engage transmission position N.
3. Release the parking brake, refer to
4.
Switch the engine off.
5.
Leave the remote control in the ignition lock
so that the vehicle can roll.
Seite 215
215
Online Edition for Part no. 01 41 2 604 231 - 03 10 500