BMW 328i Coupe 2011 User Manual

Page 57

Overriding selector lever lock

Should the selector lever refuse to move out of
position P even though the ignition is switched
on, the brake is depressed and the button on
the selector lever is pressed, the selector lever
lock can be overridden:

Unclip the sleeve of the selector lever.

Pull the sleeve up over the selector lever
until the sleeve is inside out.

Using the screwdriver from the onboard
vehicle tool kit, refer to page

154

, press the

red lever while moving the selector lever to
the desired position.

7-gear Sports automatic

transmission with double

clutch*

The concept

The 7-gear Sports automatic transmission with
double clutch is an automated manual trans-
mission with two clutches and secondary gear
sets in which the clutching and shifting is han-
dled by an electrohydraulic system.
With the 7-gear Sports automatic transmission
with double clutch, the gears are shifted without
an interruption in driving power.
You operate the 7-gear Sports automatic trans-
mission with double clutch using the selector
lever and two shift paddles on the steering
wheel.
It offers you the following functions:

either manual or automatic mode: sequen-
tial mode or drive mode

automatic downshifting and protection
against incorrect gear selection, even in
sequential mode

Launch Control, refer to page

Automatic throttle blip

System limitations

The 7-gear Sports automatic transmission with
double clutch has an overheating protection
that protects the clutch from extreme loads.

The indicator lamp lights up in yellow if
the transmission becomes too warm.
Avoid high engine loads and frequent

accelerations from zero. If the transmission is
overheated, the indicator lamp lights up in red
and the power flow to the motor is interrupted.
It is only possible to continue driving once the
transmission has cooled down.
Avoid frequent powerful accelerations from
zero and do not hold the vehicle on inclines by
pressing lightly on the accelerator while letting
the clutch slip, as this may cause the transmis-
sion to overheat.

Selector lever positions

P R N D M/S + –

Displays in the instrument cluster

The selector lever position and the engaged
gear are displayed, e.g. M4.