BMW 328i Coupe 2011 User Manual

Page 157

155

Do not remove the covers or expose the
eyes directly to the unfiltered light source

for several hours; otherwise, this could cause
irritation of the retina.

Headlight lenses

In cool or humid weather, condensation may
form on the interior of outside lamps. When the
light is switched on, the condensation will dis-
appear after a short time. The headlight lenses
do not need to be replaced.
At high humidities, e.g. water droplets may form
in the lights; have these checked by your BMW
center.,

Xenon lamps

These bulbs have a very long service life and are
highly unlikely to fail. If a xenon lamp fails never-
theless, switch on the fog lamps and continue
the journey with great care, provided that local
legislation does not prohibit this.

Have any work on the xenon lamp system,
including bulb replacements, performed

only by a BMW center or a workshop that works
according to BMW repair procedures with cor-
respondingly trained personnel. Otherwise, if
such work is carried out improperly, the high
voltage in the system presents the danger of
fatal injuries.

Access to the lamps

Switch off the lamps and take the remote
control out of the ignition lock.

Remove the upper cover from the head-
lamp. To do so, use a screwdriver to press
the catches towards the rear, see arrows,
and pull the cover forward and out.

Follow the same steps in reverse order to reat-
tach the cover.

Be careful when installing the cover; oth-
erwise, leaks could occur and cause dam-

age to the headlamp system.

Parking lamps and roadside parking
lamps, daytime running lights*

These lamps use LED technology for operation.
If they malfunction, please contact your BMW
center.

Corner-illuminating lamp*

H3 bulb, 55 watts

Switch off the lamps and take the remote
control out of the ignition lock.

Remove the cover, refer to Access to the
lamps.

Push the wire bracket out of the anchor
towards the right and fold it up.

Disconnect the plug, change the bulb and
reconnect the plug.

Insert the bulb.

Fold the wire bracket down and engage it.

Reattach the cover.

Turn signals, front

These lamps use LED technology for operation.
If they malfunction, please contact your
BMW center.