beautypg.com

BMW 328i Coupe 2011 User Manual

Page 33

background image

Refere

nce

At a gl

anc

e

Controls

Dr

iv

ing

tip

s

Mobi

li

ty

31

Opening, closing

>

Press the switch backwards to the resis-
tance point.
The glass roof and the sliding visor open
together as long as you hold the switch in
this position.

>

Press the switch backwards past the resis-
tance point.
The glass roof and the sliding visor open
automatically. Briefly press the switch again
to stop the opening movement.

You can close the glass roof in a similar manner
by pressing the switch forwards. The sliding
visor remains open and can be closed by hand.
For information on Convenient operation via the
remote control or door lock, refer to page

19

or

23

.

After switching off the ignition

When the remote control is removed or the igni-
tion is switched off, you can still operate the roof
for approx. 1 minute as long as no door has
been opened.

Pinch protection system

If the glass roof encounters an obstruction dur-
ing closing from approximately the middle of
the opening in the roof, or during closing from
the raised position, the closing movement is
interrupted and the glass roof is opened again
slightly.

Despite the pinch protection system
check and clear the roof's travel path prior

to closing it; otherwise, the safety system might
fail to detect certain kinds of obstructions, such
as very thin objects, and the roof would con-
tinue closing.

<

Closing without pinch protection

If there is an external danger, press the switch
forward past the resistance point. The roof
closes without pinch protection.

Following interruptions in electrical
power supply

After a power failure, there is a possibility that
the glass roof can only be raised. The system
must be initialized. BMW recommends having
this work done by your BMW center.

Closing manually*

In the event of an electrical malfunction, you can
move the glass roof manually:

1.

Unclip the front of the cover of the interior
lamps using the screwdriver from the
onboard vehicle tool kit, refer to page

154

.

2.

Insert the screwdriver into the openings on
each side to press the clips.

3.

Remove the control unit.

4.

Unplug the motor. Considerably less effort
will be required for manual operation.

Online Edition for Part no. 01 41 2 604 304 - © 02/10 BMW AG