BMW 128i Convertible 2011 - Manual (Page 97)

Co
n
tr
o
ls
95
Re
fe
re
n
c
e
At
a
g
la
n
c
e
D
riv
in
g ti
ps
C
o
m
m
uni
ca
ti
o
n
s
Na
v
iga
ti
on
En
te
rt
a
in
m
e
n
t
M
o
bi
lity
Instrument lighting
You can adjust the brightness of the instrument
lighting only when the parking lamps or the low
beams are switched on.
1. Push button 1 in the turn signal/high beam
lever up or down repeatedly until the appro-
priate symbol appears in the display,
accompanied by the brightness level and
the word "SET".
2. Press button 2.
3. Push button 1 up or down to select the
desired brightness level.
4. Press button 2.
The display again shows the outside tem-
perature and the time.
Interior lamps
The interior lamps, footwell lamps * , entry
lamps * , the cargo area lamp and courtesy
lamps * are controlled automatically.
The LEDs for the courtesy lamps are set in the
door handles and illuminate the ground in front
of the doors.
To avoid draining the battery, all lamps
inside the car are switched off about
8 minutes after the ignition is switched off, refer
to Start/stop button on page
55 . <
Switching interior lamps on/off
manually
Interior lamps, front and rear * :
To switch on and off, press the button.
To switch off the interior lamps, footwell
lamps
* , entry lamps * and courtesy lamps * per-
manently, press the button for the front interior
lamps for about 3 seconds.
Reading lamps
There are reading lamps at the front and rear * ,
next to the interior lamps. To switch on and off,
press the button.
Online Edition for Part no. 01 41 2 604 129 - © 02/10 BMW AG