beautypg.com

Warning triangle, Jump-starting, To jump-starting – BMW 128i Convertible 2011 User Manual

Page 222: Giving and receiv ing as sistance

background image

Giving and

receiv

ing

as

sistance

220

The first aid pouch is located on the right-hand
side of the cargo area in a storage area.

Warning triangle*

The warning triangle is located in a holder in the
trunk lid. Press the tabs to take it out.

Jump-starting

If the car's own battery is flat, your BMW's
engine can be started by connecting two
jumper cables to another vehicle's battery. You
can also use the same method to help start
another vehicle. Only use jumper cables with
fully-insulated clamp handles.

Do not touch any electrically live parts
when the engine is running, or a fatal acci-

dent may occur. Carefully adhere to the follow-
ing sequence, both to prevent damage to one or
both vehicles, and to guard against possible
personal injuries.

<

Preparation

1.

Check whether the battery of the other
vehicle has a voltage of 12 volts and
approximately the same capacitance in Ah.
This information can be found on the bat-
tery.

2.

Switch off the engine of the assisting vehi-
cle.

3.

Switch off any consumers in both vehicles.

There must not be any contact between
the bodies of the two vehicles; otherwise,

there is a danger of shorting.

<

Connecting jumper cables

Connect the jumper cables in the correct
order to prevent sparking at the battery,

which could cause injury.

<

Your BMW has a jump-starting connection in
the engine compartment which acts as the bat-
tery's positive terminal, refer also to the Engine
compartment overview on page

203

. The cap is

marked with +.

1.

Pull the cap of the BMW jump-starting con-
nection up to remove.

2.

Attach one terminal clamp of the plus/+
jumper cable to the positive terminal of the
battery or a starting-aid terminal of the vehi-
cle providing assistance.

3.

Attach the second terminal clamp of the
plus/+ jumper cable to the positive terminal
of the battery or a starting-aid terminal of
the vehicle to be started.

4.

Attach one terminal clamp of the minus/–
jumper cable to the negative terminal of the
battery or to an engine or body ground of
the assisting vehicle.

Online Edition for Part no. 01 41 2 604 129 - © 02/10 BMW AG