Dogtra YS300 - Manual (Page 7)

12
DESCRIPTION
Contact Points
uses surgical stainless steel contact
points. The length of the contact points should be
well-fitted so that the contact points are held
firmly against the dog’s skin.
IMPORTANT : Avoid touching the Contact
points unless the No Bark Collar is completely
discharged, or you may feel the electrical
stimulation yourself.
Plastic Dummy Contact Points
If your dog is properly trained with the no bark
collar, you can replace the Contact Points with
the Plastic Contact Points included in the
package. By doing so, it will allow you to keep
the collar on your dog for a longer period of time
with less irritation on the skin. You may also use
the Pager mode as a useful tool in correcting your
dog without the stimulation, however, only leave
the collar on for 8-hours at a time if the stainless
steel contact points are still being utilized.
13
DESCRIPTION
The collar strap of the dogtra YS300 can be
adjusted 3 steps as shown in the diagram above.
To adjust the collar strap, first unscrew the contact
points and put the screws in the desired holes, then
tighten the contact points as shown below.
Collar Strap Adjust