Dogtra YS300 - Manual (Page 10)

18
FITTING THE COLLAR
The collar strap should be adjusted so that the
contact points are held firmly against the dog’s
skin.
Fasten the collar enough to allow one or two
fingers to fit between the collar strap and your
dog’s neck.
If the collar is too loose, the stimulation can be
inconsistent and your corrections will be
inconsistent also.
Periodically wash the No Bark Collar with
alcohol or detergent. Dry thoroughly after
washing.
FITTING THE COLLAR
MAINTENANCE
19
TROUBLESHOOTING
My dog keeps barking. Is the No Bark Collar
working properly?
� Check and see that the Dogtra No Bark Collar
is turned on.
� Tighten the collar strap and make sure the
contact points are held firmly against the
dog’s skin.
� Recharge the battery if it is discharged.
� Increase the electric stimulation levels.
- We advise you to start with the lowest level
when first using the “ ”.
- The dog can be startled at the electrical
correction for the first time.
- If you consider the intensity of stimulation
too light, increase the level gradually.
- In case of stubborn or aggressive dogs, you
can increase the intensity level suddenly,
and then return the intensity back to its
original setting.
- You have to be very careful in deciding the
intensity level.
If you select the wrong intensity level, the
electrical contact can be inconsistent or it
can give rise to negative influences on dogs.
� For more information, contact the customer
service center at 1-888-811-9111
(8:30am-4:00pm PST)
TROUBLESHOOTING