Dogtra iQ Plus User Manual

Page 11

Warning
1. Fully charge the unit before using it for

WKH¿UVWWLPH

2. Do not charge the batteries near any

ÀDPPDEOHVXEVWDQFHV

3. Fully charge the batteries if the unit is to

be stored without use for a period of one
month or more.

4. Always use iQ Pet approved chargers.

If improper chargers are used, the LED
ZLOOÀDVKLQDPEHURUPD\QRWOLJKWXSDW
all.

7. Charging the battery

8. Code Setting

1-Dog code setting
1. Start with the receiver/collar turned off

and the Rheostat intensity dial level on
the handheld transmitter set to “0”.
On the handheld transmitter, slide the
dog selector switch left to align with “I”.

2. Place the red dot on the back of the

handheld transmitter to the red dot on
the receiver/collar. Hold the two red dots
together for 5 seconds.
Release them when the green LED
blinks rapidly on the receiver/collar.

3. With the handheld transmitter, press the

Nick and Constant buttons simultaneously.
The code setting has been successfully
done if the receiver/collar vibrates
when the pager button is pressed on
the handheld transmitter.

2-Dog code setting
1. Start with the receiver/collar turned off

and the Rheostat intensity dial level on
the handheld transmitter set to “0”. On
the handheld transmitter, slide the dog
selector switch right to align with “II”.

2. Place the red dot on the back of the

handheld transmitter to the red dot on
the receiver/collar. Hold the two red dots
together for 5 seconds.
Release them when the green LED
blinks rapidly on the receiver/collar.

3. With the handheld transmitter, press the

Nick and Constant buttons simultaneously.
The code setting has been successfully
done if the receiver/collar vibrates
when the pager button is pressed on the
handheld transmitter.

8. Code Setting