Dogtra 1200 Series - Manual (Page 16)

29
TESTING
Testing the “Pager” Feature:
If you have a dogtra collar with the pager feature,
push the”Pager” button while holding the
receiver in your hand. You should feel the collar
vibrate.
28
TESTING
2. Place the test light on the receiver contact
points and hold it there.
3. Set the transmitter intensity dial to level
one hundred and push the “Constant” button.
4. Watch the test light as you push the
“Constant” button on the transmitter.
It should glow brightly. As a safety feature the
collar will automatically turn off after twelve
seconds. To reactivate, release the button for
one second and the collar will reset.
5. Push the “Nickt” button. The test light should
light for just a moment.
6. Change the intensity dial to level fifty and
repeat the test. The test light should glow
dimmer.
NOTE : It is normal for the test light not to come
on if the intensity level is set below level ten.