Bercomac Subframe & Drive Mechanism for JOHN DEERE Series X300 - Manual (Page 8)

6
ASSEMBLY
Turn the front wheels towards the right.
Install the pivot support (item 1) between the two
supports (items 2 & 3).
Secure in place by sliding the pin (item 4) from the right
side in the holes of the supports.
Lock into place by placing the bended part of the pin
(item 5) in the hole that is free on the right support.
Secure in place with a 3 mm hair pin (item 6).
Tighten firmly the lock nuts (item 7) previously installed.
Install the short link
STEP 2
LIFT SYSTEM INSTALLATION:
Insert the long part of the intermediate arm (item 1) in
the hole (item 2) on the right side of the tractor frame,
then insert the other end in the hole (item 3) on the
left side.
On the right side, install the bushing (item 4) on the
end of the intermediate arm, then push it through the
hole (item 2) and secure with a cotter pin 5/32" x
1" (item 5).
From under the tractor, install one end of the short
link (item 1) on the support (item 2) of the
intermediate arm.
NOTE: Make sure the support (item 2) is pointing
upwards.
Secure at each end with a pin (item 3) and a 2.5mm
hair pin (item 4) as shown.
Install pivot support
Install the intermediate arm