BMW 2007 bmw 328i User Manual
Page 95
A change in the tire inflation pressure during
driving is taken into account.
A correction is only necessary if this is indicated
by the TPM
Wheels, green
The tire inflation pressure is equal to the target
state.
One wheel is yellow
A flat tire or major drop in inflation pressure in
the indicated tire.
All wheels are yellow
▷
A flat tire or major drop in inflation pressure
in several tires.
▷
The system was not reset after a wheel
change and thus warns based on the infla‐
tion pressures initialized last.
▷
A flat tire in one or more tires while the sys‐
tem is being reset.
Wheels, gray
The system cannot detect a flat tire. Reasons for
this may be:
▷
TPM is being reset.
▷
Disturbance by systems or devices with the
same radio frequency.
▷
Malfunction.
Resetting the system
Reset the system after each correction of the
tire inflation pressure and after every tire or
wheel change.
1.
"Vehicle Info"
2.
"Vehicle status"
3.
"Reset"
4.
Start the engine - do not drive away.
5.
Reset the tire pressure using "Reset".
6.
Drive away.
The tires are shown in gray and "Resetting
TPM..." is displayed.
After driving for a few minutes, the set tire infla‐
tion pressures are applied as set values. The re‐
setting process is completed automatically dur‐
ing driving. The tires are shown in green and
"TPM active" is shown on the Control Display.
The trip can be interrupted at any time. If you
drive away again, the process resumes auto‐
matically.
If a flat tire is detected during a reset, all tires are
displayed in yellow.
Low tire pressure message
The yellow warning lamp lights up. A
Check Control message is displayed.
▷
There is a flat tire or a major loss in
tire inflation pressure.
▷
The system was not reset after a wheel
change and thus warns based on the infla‐
tion pressures initialized last.
1.
Reduce your speed and stop cautiously.
Avoid sudden braking and steering maneu‐
vers.
2.
Check whether the vehicle is fitted with reg‐
ular tires or run-flat tires.
Run-flat tires, refer to page
with a circular symbol containing the letters
RSC marked on the tire sidewall.
Do not continue driving without run-flat
tires
Do not continue driving if the vehicle is not
equipped with run-flat tires; continued driving
may result in serious accidents.◀
When a low inflation pressure is indicated, DSC
Dynamic Stability Control is switched on if nec‐
essary.
Actions in the event of a flat tire
Normal tires
1.
Identify the damaged tire.
Seite 95
Safety
Controls
95
Online Edition for Part no. 01 40 2 608 633 - 11 09 490