6specifications, 7accessories, Specifications – Cooper Instruments & Systems DPG 100 Digital Pressure Test Gage User Manual
Page 8: Accessories

2.6 Specifications
These specifications are subject to change without notice.
Enclosure Rating:
NEMA 2 (standard),
NEMA 4 (optional; not available with AC Adapter
power)
Diameter:
3.7 inches
Linearity and Hysteresis:
.2% of full-scale, linearity and hysteresis (better than
test gauge accuracy)
Operating Temperature:
30 to 160 °F (standard),
0 to 180 °F (with NEMA 4 option)
Pressure Ranges 0 to:
1, 5, 15, 30, 50, 100' 200, 300, 500, 750, 1K, 1.5K,
2K, 3K, 5K, 7.5K, 10K PSI
Calibration Engineering Units:
PSI
Built-in Engineering Unit
Conversion:
PSI, bar, mbar, inH
2
O, inHg, kPa, mmHG, MPa,
ftH
2
O (field selectable)
Special Engineering Units:
Optional
Display:
4 ½” LCD digits, 0.5 inches high
A-to-D converter sample rate:
7.8 kHz
Frequency Response ( -3dB):
.78Hz
Display, Limits and Output
Update Rate:
3 per second
Pressure Port:
below 500 PSI:
1/4-18 NPT male
500 PSI and above:
9/16 -18 UNF-2B female with SAE spec J514 O-ring
boss
Power Requirements:
Battery Powered:
one or two 9 Volt alkaline batteries
AC Adapter Powered:
110 VAC@60 Hz adapter (included)
Vehicle (DC) Powered:
11 to 32 VDC (3 ft. cable included)
Wetted Parts:
Stainless steel
Housing Material:
Stainless steel
High and Low Capture:
Standard, same update rate as display
Zero and Span Adjustment:
Standard
Front Panel Membrane:
Tactile feedback, raised buttons
Calibration Data:
Stored on non-volatile memory chip
2.7 Accessories
< 500 PSI
instruments
>= 500 PSI
instruments
PRESSURE ADAPTERS (Zinc Plated Steel)
To 1/4 -18 NPT female
√
√
To 1/4- 18 NPT male
N/A
√
To 7/16- 20 UNF male with 37 degree flare
√
√
PRESSURE ADAPTERS (Stainless Steel)
To 1/4 -18 NPT female
√
√
To 1/4- 18 NPT male
N/A
√
To 7/16- 20 UNF male with 37 degree flare
√
√
PANEL MOUNTING RING
√
√
CARRYING CASE
√
√
DPG 100
5
Rev Feb 2001