Bio-Rad VersaFluor™ Fluorometer - Manual (Page 9)

Below are the DIP switch settings to use with the VersaFluor Fluorometer. Please refer
to the printer manual for full descriptions of the DIP switch settings.
DIP SW1
Switch No.
Action Setting
1 Press FEED (OFF)
2 Press ONLINE (ON)
3 Press ONLINE (ON)
4 Press FEED (OFF)
5 Press ONLINE (ON)
6 Press FEED (OFF)
7 Press ONLINE (ON)
8 Press ONLINE (ON)
DIP SW2
Switch No.
Action Setting
1 Press ONLINE (ON)
2 Press ONLINE (ON)
3 Press ONLINE (ON)
4 Press ONLINE (ON)
5 Press ONLINE (ON)
6 Press ONLINE (ON)
7 Press ONLINE (ON)
8 Press FEED (OFF)
DIP SW3
Switch No.
Action Setting
1 Press ONLINE (ON)
2 Press ONLINE (ON)
3 Press ONLINE (ON)
4 Press FEED (OFF)
5 Press FEED (OFF)
6 Press ONLINE (ON)
7 Press ONLINE (ON)
8 Press ONLINE (ON)
VersaFluor Fluorometer
The baud rate and flow control parameters is set on the VersaFluor Fluorometer in order
to communicate with the thermal printer. Set the baud rate to 9600 and the flow control to
XON. See Section 4.8 for serial port function and parameters.
6