Bio-Rad BioFrac™ Fraction Collector - Manual (Page 12)

1 | Introduction
4 | BioFrac Fraction Collector
 Optional drop former optimized for small-volume drop dispensing
(recommended when collecting into microplates)
 Ability to start/stop an external pump and chart recorder
 Screen sleep mode for longer display life
Unpacking
When unpacking the fraction collector, carefully inspect the containers for any
damage that may have occurred in shipping. Severe damage to a container may
indicate damage to its contents. If you suspect damage to the contents may have
occurred, file a claim immediately with the carrier in accordance with their
instructions before contacting Bio-Rad Laboratories.
Caution: Do not lift the fraction collector by its dispenser arm.
Grip the base of the fraction collector and lift it slowly out of its packing. Do not lift
the unit by its dispenser arm. Remove the remaining contents from each of the
boxes and check all of the parts against the supplied packing list. The BioFrac
fraction collector is shipped with the following:
 Fraction collector unit
 AC power cord
 Fittings kit ( Figure 2 )
 Instruction guide
 Tube rack #F1 (2) for 12–13 mm tubes
 Diverter valve (including an hex key)
 Combicon connector (included with instruction guide)
Note: If any part is missing or damaged, contact Bio-Rad Laboratories
immediately.