1-5 go to temporary waypoint, 1-6 edit or delete a temporary waypoint – B&G H50 Wireless VHF Handset User Manual
Page 20
3.
Press ENT to set the nearest waypoint as the active waypoint OR move the cursor to
another waypoint and then press ENT.
The chosen waypoint is shown on the bottom line of the LCD.
3-1-5 Go to temporary waypoint
MENU SELECT
►WAYPOINT
BACKLIGHT
BUDDY LIST
LOCAL/DIST
▼
WAYPOINT
WP LIST
NEAREST WP
►TEMP
TEMP
►TEMP1
TEMP2
TEMP1
►GO
TEMP EDIT
DELETE
1.
Select WAYPOINT then TEMP.
2.
Your temporary waypoint list is displayed. There are 3 choices for quick access.
3.
Select the temporary waypoint to go to. Press ENT.
4.
Press ENT to set the temporary waypoint as the destination waypoint. It is immediately
shown on the bottom line of the LCD.
Tip: Hold down MOB and release before the 3 second countdown completes. Your current LL
position is stored in TEMP1 to TEMP3 in the waypoint list.
If the list is full, a message appears. See following section to delete a TEMP WP.
TEMP IS
FULL
3-1-6 Edit or delete a temporary waypoint
MENU SELECT
►WAYPOINT
BACKLIGHT
BUDDY LIST
LOCAL/DIST
▼
WAYPOINT
WP LIST
NEAREST WP
►TEMP
TEMP2
GO
TEMP EDIT
►DELETE
DELETE
►YES
NO
WAYPOINT
WP LIST
NEAREST WP
►TEMP
TEMP
TEMP1
►TEMP2
1.
Select WAYPOINT then TEMP. Your temporary waypoint list is displayed.
2.
Select the temporary waypoint to edit then select TEMP EDIT.
Note: To delete the temporary waypoint, select DELETE then YES. The temporary waypoint is
deleted immediately and the temporary waypoint list is displayed again.
B&G - V50 & H50 Operation Instructions
20