B&G Zeus2 Glass Helm CPU - Manual (Page 56)

Locking remote stations
The AP24/AP28 includes a Remote Lock function that will disable autopilot control from
other units. A locked control unit is indicated with a key symbol in autopilot controller pop-
up.
When the remote lock function is enabled on an AP24/AP28 control unit, only the active
control unit stays in command. No transfer of command to Zeus
2 Processor or other
autopilot control units on the system can take place,
You can only unlock the remote stations from the AP24/AP28 unit in command.
Using the autopilot in an EVC system
When the Zeus 2 Processor is connected to an EVC system via the SG05, you can take manual
control of the steering regardless of the autopilot mode.
The mode indicator on the pilot pop-up will be replaced by a dash to indicate EVC override.
The system will return to Zeus
2 Processor control in standby mode if no rudder command is
given from the EVC system within a predefined period.
Autopilot settings
Chart compass
You can elect to show a compass symbol around your boat on the chart panel. The compass
symbol will be off when the cursor is active on the panel.
Locking autopilot operation from a unit
You can lock a display to prevent unauthorized operation of the autopilot. When the unit is
locked this is indicated with a lock symbol and with text in the pop up. No automatic modes
can be selected from a locked display.
Ú Note: The lock function is not available on a display which has autopilot control!
If the Zeus 2 Processor is part of an AP24/AP28 system, all other autopilot control units can be
locked for autopilot control from the AP24/ AP28 control unit.
56 Autopilot | Zeus 2 Glass Helm