B&G Zeus2 12 - Manual (Page 13)

CZone dashboard
When the CZone is installed and configured, an additional CZone dashboard will be added
to the Instrument panels.
You switch between a panel’s dashboards by selecting the left and right arrow symbols or by
selecting the dashboard from the menu.
Editing a CZone dashboard
You can customize a CZone dashboard by changing the data for each of the gauges.
Available editing options depend on the type of gauge and which data sources that are
connected to your system.
For more information refer to "Instrument panels" on page 84.
GoFree TM wireless
With a WIFI-1 unit connected to the Zeus 2 system you can use a wireless device to remotely
control the Zeus 2 . The Zeus 2 is controlled from the wireless device by Apps downloaded
from their relevant Application store.
Ú Note: For security reasons, Autopilot and CZone functions cannot be controlled from a
wireless device.
Installation and wiring of the WIFI-1 unit are described in the separate WIFI-1 Installation
Guide. Configuration and setup are described in the Zeus
2 Installation manual.
Operating the Zeus 2 with a wireless device
When remote control is accepted, the Zeus 2 page will be mirrored to the wireless device.
The Zeus 2 image includes softkeys with the same functionality as the unit. Selecting these
keys works as operating the similar hard keys on the Zeus 2 .
H5000 integration
The Zeus 2 system integrates with B&G’s H5000 Instrument and Autopilot system.
The H5000 icon will be available in the Tools panel on the Home page when an H5000
system is available on the network.
A separate manual is provided with the H5000 system. Refer to this documentation and to
the Zeus
2 Installation manual for how to install and configure the H5000 system.
Remote controllers
You can connect a ZC1 to the network and remotely control the Zeus 2 .
A separate manual is included with the remote controller.
Introduction | Zeus2 Operator Manual 13