Amico Light-Duty Monitor Arm - Manual (Page 5)

www.amico.com 5
SECTION 2: Installation Preparation
Installation, Tools and Part Requirements
• HEX key sizes: 2.5 mm; 1/8" (3.2 mm), 5 mm; 6 mm
• Philips Head Screwdriver size: #3
• 1/2" (12.7 mm) Socket wrench
WARNING It is the installer’s responsibility to ensure all components are properly assembled and installed
using the provided instruction manual.
WARNING Using improperly sized screws may damage your display. If spacers are required, be sure to use
correctly sized screws. Properly sized screws will easily and completely thread into the display mounting holes.
WARNING Exceeding weight capacities can result in severe personal injury or damage to equipment. It is
the installer’s responsibility to ensure the combined weight of all components does not exceed the weight
capacity of 8-17 lbs (3.6-7.7 kg).
WARNING Allowing any part of the component cables to be caught between movable parts can result in
serious personal injury or damage to equipment.
WARNING The arm will spring upward and may cause personal injury or equipment damage when the
monitor is removed, due to the change in weight. Secure the arm first by lifting the arm to be in the fully UP
position when monitor is removed.
WARNING The mounting platform must be strong and stable enough for supporting the monitor as well as
the arm.
WARNING Verify that rails have been installed in accordance with Amico rail installation instructions. Rail
failure with mounted devices can cause serious injury and equipment damage.
WARNING Do not position the LMA above a patient.
WARNING It shall be the responsibility of the hospital, its consultants and/or contractors to determine if
the mounting surface is adequate to safely mount the specific instrument. This includes the selection of
appropriate fasteners and the proper installation, REGARDLESS OF WHAT IS SUPPLIED WITH YOUR LMA. See rail
instructions for specific wall channel guideline information.
WARNING DO NOT attempt to mount/remove the LMA from the rail when loaded with any instrument.
WARNING To prevent mounting adapter from sliding down the rail, ensure that all set screws are fastened
to the tightest possible position. Serious injuries could result if the set screws are not properly fastened.
Contact Amico Accessories Inc. to discuss solutions not covered in this manual at 1.877.264.2697