ADS Environmental Services PrimeProbe2 QR 775016 A0 - Manual (Page 32)

PrimeProbe2 User Manual
28
#2 IMP +/- Pulse on N.2 for net flow
Sign Flow direction output
Range Range Indication output
Max. Al+ Flow exceeds Maximum Threshold+
Max Al- Flow exceeds Minimum Threshold -
Max +/- Flow exceeds Net threshold
Min Al+ Flow below Minimum Threshold +
Min Al - Flow below Minimum threshold -
Min Al +/- Flow below net threshold
P. pipe Empty Pipe alarm
 Out2 = Is set to the output functions of Out2 and is configured
using the same procedures as Out1.
Communications
Besides the integrated keypad of the PrimeProbe2 with remote display,
only one other communication protocol exists. This protocol, IF2, uses a
PrimeProbe-PC link cable (USB) for configuration. The user can also
configure the PrimeProbe2 using the PrimeWorks software with this
protocol.
Set this parameter to HTP for PrimeWorks communication.
Display
 Language Allows the user to select from among several
languages for the PrimeProbe2 display:

E = English

I = Italian

F = French

S = Spanish
 T+ reset Allows the user to reset the Forward Totalizer using the
keypad. Simply press Enter, and the Execute? message will
appear. HOLD Enter again, and a Done message will display.
 P+ reset Allows the user to reset the Partial fFrward totalizer.
Use the same procedure as described in T+ reset.
 T- reset Allows the user to reset the Reverse Totalizer. Use the
same procedure as described in T+ reset.
 P- reset Allows the user to reset the Partial Reverse Totalizer.
Use the same procedure as described in T+ reset.
 D. Times Allows the user to set the amount of time, since the
keypad was last used, before the display turns itself OFF. Enter
this value in seconds. To turn the display back ON, simply hold