Update lh aft rod end, Install lh valve – Great Plains NP4000 Applicators User Manual
Page 10
10
Great Plains Manufacturing, Inc.
Spring Plunger Update
401-828M
2012-08-30
Update LH Aft Rod End
Refer to Figure 14 and Figure 15
44. At the rod end of the aft fold cylinder, mark hoses
with letters as follows:
45. At that rod end, remove the fittings. They may be:
and are not re-used.
46. Select one saved:
811-077C TE 3/4MORB 3/4MJIC 3/4MJIC
Secure it to the rod end port.
47. Connect hose
48. Select one new hose:
Connect one end to the tee.
Install LH Valve
49. Select the new LH valve assembly:
with fittings pre-installed (from step 35 through
step 38 if not shipped pre-assembled)
Orient the valve above the rod end of the aft
cylinder, with the actuator pointing toward machine
center, and the fitting tree with the tee
pointing to
machine rear.
50. Route new hose
under the aft cylinder. Connect
it to side elbow
51. Connect existing wing-to-wing hose
to the center
port of tee
52. Connect existing inner-to-outer hose
outboard MJIC end port of tee
53. Route hose
under both cylinders. Connect it to
the inboard end MJIC port of tee
forward-to-aft rod-end cylinder-to-cylinder
hose
wing-to-wing-side rod-end cylinder-to-cylinder
hose
inner-to-outer wing rod-end cylinder-to-cylinder
hose
Figure 14
Existing LH Aft Rod End
34096
A
B
D
C
LH
Figure 15
Updated LH Aft Rod End
34097
LH
C