Great Plains 2N-3010 Operator Manual - Manual (Page 16)

12 2N-2410/3010 SGS Table of Contents Index Great Plains Manufacturing, Inc.
133-029M Table of Contents Index 2013-05-23
Drive Chain Routing
Refer to Figure 9
Route and assemble the chains onto the sprockets as
shown and tighten the idlers.
Bolt rear drive guard in place with the u-clips
1 ⁄
4
in x
5 ⁄
8
in long bolts and lock washers .
Refer to the Hose Retainer Assembly Option or Y-Tube
Option, depending on which you have ordered, for proper
hose routing.
Seed Cup Covers
Refer to Figure 10
The same small seeds boxes are used for both the
7
1 ⁄
2
inch and 8 inch spacings. If the 8 inch spacing is
used a seed cup cover (part number 123-190D) will need
to be installed to cover the unused openings (2 on the
24 foot drills and 4 on the 30 foot drills). Install them on
the inside of the boxes and under the seed cup bolts.
1 2
3 4
Figure 9
Chain Routing
13386
Figure 10
Seed Cup Cover
11655