Great Plains 3S-4000HDF Predelivery Manual - Manual (Page 19)

Setup 17
12/10/2009 195-067Q
Refer to Figure 21
5.
Use crank to raise jack foot. Remove pin and jack.
Store jack on top of tongue.
Electrical Connections
If the tractor will be used for movement of the drill, the
lighting connection needs to be made. There may be one
or two additional connectors present on the drill, depend-
ing on options ordered.
Refer to Figure 22
1.
Plug drill electrical lead into tractor seven-pin connec-
tor. If your tractor is not equipped with a seven-pin
connector, contact your dealer for installation.
2. If the tractor currently hitched is the primary tractor
that will be used with the drill, any additional electrical
connections will be made under the topic “Install
Final Accessories” on page 29.
Otherwise, secure any cables not connected so that they
do not contact the ground during movement.
Figure 21
Jack on Storage Stob
18940
Figure 22
Lighting Connector
26467