Great Plains 3S-4000HDF Predelivery Manual - Manual (Page 16)

14 3S-4000HD
195-067Q 12/10/2009
Open Center Conversion
If the drill was shipped with an Open Center kit, it is not
factory-installed. Install it now. An installation manual is
provided.
Point Row Option
If the Point Row Option was ordered with the drill, the
hydraulics and drill electrical lead are factory-installed.
If the customer’s primary tractor is available, install the
control module in the tractor cable and make the electrical
connection. Consult the Point Row installation manual
provided.
If the primary tractor is not available, temporarily connect
the control module so that openers can be operated dur-
ing Setup.
Post Assembly Checklist
• Check that all working parts are moving freely, bolts are
tight, and cotter pins are spread.
• Check for proper tension and alignment on all drive
chains.
• Check that all safety decals and reflectors are located
correctly and are legible. Replace if improperly located
or damaged. Refer to “Safety Decals” in the Operator’s
manual.
• Inflate tires to recommended pressures as listed on the
“Tire Inflation Chart” on page 31. Tighten wheel bolts
as specified on “Torque Values Chart” on page 32.
BASE END
, CENTER OPENERS
ROD END
CENTER OPENERS
BASE END
WING OPENERS
ROD END
WING OPENERS
P
G
R
T
P
G
R
T
3
LOWER
TO TRACTOR
RAISE
1 2
3
1
2
3
FILTER
Figure 16
Open Center Conversion
18750
Figure 17
Point-Row Connector
26469