Great Plains 1500TM Assembly Manual - Manual (Page 27)

Great Plains Manufacturing, Inc. Assembly 23
12/12/2013 586-535Q-ENG
Refer to Figure 23
91. Pivot level bar
and the level bar spring assembly
until holes in plates are aligned.
92. Re-install 3/4 x 2 Gr. 8 bolts , secure with 3/4 lock
washers and 3/4 nuts.
93. Torque 3/4 x 2 Gr. 8 bolts to 375 ft lbs to be sure
bolts do not work loose and cause damage to
machine.
Completing Setup
94. The decals may now be installed.
95. See appropriate pages for decals in the “Parts Manual”
for decal placement.
96. To install new decals:
a.Clean the area on which the decal is to be placed.
b.Peel backing from decal. Press firmly on surface,
being careful not to cause air bubbles under decal.
c.Slowly peel away top protective covering being care-
ful not to pull decal from implement.
97. If machine has an optional finishing attachment or rear
hitch, refer to the “Parts Manual” for parts break down
and attachment layout drawings of this manual.
98. Be sure to consult the operating instructions, in “Oper-
ator’s Manual”, for the first time field adjustments
before going to the field.
Figure 23
Level Bar
43106
2
3
1
2 3
1
1