Before you start, Compatibility, Inventory – Great Plains 3P606NT Assembly Instructions User Manual
Page 2: Comprehension, Pre-assembly preparation, Tools required

Great Plains Mfg., Inc.
2
Small Seeds Option
133-140M
04/02/2009
Before You Start
Compatibility
Make sure that the drill is a compatible model for the
kit. See table on page 1. The full model number for
the drill is found on the serial number plate.
2.
If the drill is a model 605NT or 606NT, you may want
to replace the ‘606 decal in the kit with the correct
decal for your drill. It is not necessary to have these
decals on hand during the kit installation.
Order one of:
838-207C DECAL 605NT
838-203C DECAL 3P605NT
Inventory
3.
Make sure all parts are present. Remove all parts
and any packing material from inside the new Small
Seeds box.
Comprehension
4.
Review these instructions. Make sure the installers
understand where each part or assembly is
installed, and what tools are required for the task.
Note: Illustrations in this manual, based on the parts
manuals for this family of drills, may show
exploded views that are fully disassembled. Rely
on the instructions for required disassembly and reassembly steps.
Pre-Assembly Preparation
Tools Required
• updated drill Parts Manual (see page 1)
• suitable tractor for positioning and lowering drill
• blocks for securing transport tires if drill will be
unhitched for the work
• two people or a hoist - several longs parts are suitable
for unassisted single-person removal/installation
• chain lube
• basic hand tools, including:
snap ring pliers
Figure 2
Serial Number Plate
18515