Great Plains 3P606NT Assembly Instructions - Manual (Page 16)

Great Plains Mfg., Inc.
16 Small Seeds Option
133-140M 04/02/2009
Refer to Figure 24
70. If this is a Native Grass drill, locate the center of the
new walkboard. Otherwise, use the same walkboard
hole from which the SMV was removed at step 10.
71. Select one saved:
890-153C SMV MOUNTING BLADE
and two sets saved set:
802-007C HHCS 5/16-18X3/4 GR5
804-009C WASHER LOCK SPRING 5/16 PLT
803-008C NUT HEX 5/16-18 PLT
Re-install the still-assembled SMV at walkboard
center.
Check System Function
72. Lubricate new chains.
73. Hitch tractor.
74. Raise and lower drill, checking for excess tension or
slack in new seed hoses.
75. Raise drill. Exercise the calibration procedure for
the drill, checking for correct operation of all new
sprockets and chains.
Small Seeds Operation
Make sure you have the latest Operator and Seed Rate
manuals for your drill. Details of Small Seeds box adjust-
ment and calibration are covered in the Seed Rate man-
ual.
Small Seeds rate is set entirely by the rate handle on the
new SGS box and is unaffected by the Drive Type setting
used for the Main seed box.
Unless also metering from the Main box and/or Native
Grass box at the same time, prevent wear by disconnect-
ing chains, or reduce Main box wear by setting the Drive
Type to 1.
Figure 24
Re-mount SMV
18565
89
85
93
96
96
85
93
89