beautypg.com

Checking singulated rates – Great Plains YP1630F-1670 Material Rate User Manual

Page 9

background image

Great Plains Manufacturing, Inc.

Contents

Appendix

Seed Rate

7

2012-12-04

Contents

Appendix

401-832B

Checking Singulated Rates

1.

Determine the sample distance to check. Find your
row spacing in the table at right.

2.

Note the number of rows to sample. Adjust the
planting depth to a shallow setting on one or two
outside rows (per table). Tie up the press wheel
arms with wire or bungee to prevent furrow closure.

3.

Decide whether to use 1/1000th or 1/200th of a
hectare or acre as the sample size. 1/200th provides
a more accurate sample.

4.

Configure the planter for the chart rate, either using
the chart settings for sprockets, or, with hydraulic
drive, selecting the rate on the seed monitor.

5.

Plant at the desired planting speed for slightly more
than the computed sample run length.

6.

Measure off the sample distance, balanced in
between where seeding started and stopped.

7.

Count the number of seeds over the distance
measured. Also note the consistency of the seed
spacing.

8.

Compute the rate for a full acre or hectare.

For a 1/1000th sample, multiply the counted seeds
by 1000.

For a 1/200th sample, multiply the counted seeds by
200.

9.

If the field and chart rates vary by more than a few
percent, re-check planter setup, including meter
wheel or finger count, air system, tire size, tire
pressures, sprocket or hydraulic drive setup, chain
slack, etc. If seed spacing is irregular, this suggests
a seed delivery problem, and not a rate setup
problem.

10. While planting, pay attention to the seed monitor. In

addition to confirming the single-row furrow check, it
will also provide field rate data on all the other rows,
and alert you to any irregularities or stoppages.

Rows to Sample

Length of Sample Run

Row

Spacing

Rows

to Count

1/1000th

1/200th

70 cm

1

ha: 14.29 m

71.45 m

30 inches

1

ac: 17 ft. 5 in.

87 ft. 1 in.

Metric Example:
Sample size:

1/1000th ha

Plant for approximately:

20 meters

Measure the central:

14.29 meters (1429 cm)

USc Example:
Sample size:

1/1000th ac

Plant for approximately:

25 feet

Measure the central:

17 feet 5 inches

Metric Example:
Seeds counted:

82

Computed for full hectare:

82 x 1000 = 82 000

This differs from chart by
less than 1%

USc Example:
Seeds counted:

31

Computed for full acre:

31 x 1000 = 31,000

This differs from chart by
less than 1%

This manual is related to the following products: