ClearOne StreamNet Infrastructure and Network - Manual (Page 19)

Chapter 2: Switch Configuration Settings 16
Configure Switchport Access and Mode for VLAN. •
Configure
Interface Range Ethernet All
Switchport access VLAN 2
Switchport mode access
NON-NeTSTreamS Or CLearONe BraNded imPLemeNTaTiON
StreamNet generic QoS Switch requirements recommendations
requirements for audio Only StreamNet applications
10/100BASE-T Auto-sensing Fast Ethernet switching ports •
Recommended Gigabit uplink ports for multiple switches in network •
IGMP v2 or v3 support •
Multicast support with filtering •
Auto-negotiation for Speed, Duplex Mode and Flow Control •
requirements for Loss-less or motionTX audio/Video StreamNet applications
100/1000BASE-T auto-sensing Gigabit Ethernet switching ports •
10 Gigabit Ethernet uplink modules •
IGMP v2 or v3 support •
Multicast support with Filtering •
Auto-negotiation for Speed, Duplex Mode and Flow Control •
additional StreamNet requirements for global and VLaN applications
Set a switch or VLAN IP Address. •
Turn on IP IGMP v2 or v3 (Internet Group Management Protocol) Querying. •
Turn on IP IGMP v2 or v3 Snooping. •
Turn on IP Routing. •
Turn off STP (Spanning Tree Protocol) or set STP to Rapid Mode. •
Turn on Multicast Filtering. •
Turn off IP IGMP Snooping TCN Flooding. •
StreamNet access Point requirements
Turn on Switchport Host Mode. •
Turn on IP IGMP Snooping. •
Turn on IP IGMP Immediate-Leave or Fast-Leave. •
Turn off STP (Spanning Tree Protocol) or set STP to Rapid Mode. •
Turn off IP IGMP Snooping TCN Flooding. •
StreamNet Switch Uplinks requirements
Turn off IP IGMP Immediate-Leave or Fast-Leave. •