ClearOne StreamNet Infrastructure and Network - Manual (Page 17)

Chapter 2: Switch Configuration Settings 14
dell 6224 - 6248 Switch Settings
Create VLAN and set the Switch or VLAN IP address (StreamNet devices should reside on •
same VLAN)
Set the “Bridge Multicast Forbidden Forward-Unregistered” function to forbid Forwarding-
•
Unregistered-Multicast-Addresses.
Set the “Network Directed Broadcast” function to forward Broadcast commands.
•
Turn on IP IGMP v2 or v3 Querying and set the Query Interval. •
Turn on IP IGMP v2 or v3 Snooping, set Interval and Leave Time •
Turn on IP Routing. •
Turn off STP (Spanning Tree Protocol) or set STP to Rapid Mode. •
Turn on Multicast Filtering. •
Turn on Jumbo Frame Support (only needed with uncompressed streams). StreamNet stream •
packets are MTU 4096.
Configure Switchport Access for VLAN and Mode.
•
Turn off IP IGMP Snooping TCN Flooding. •
aCCeSS POrTS
Turn on Switchport Host Mode. •
Turn on IP IGMP Snooping. •
Turn on IP IGMP Immediate-Leave or Fast-Leave. •
Turn off STP (Spanning Tree Protocol) or set STP to rapid mode. •
Turn off IP IGMP Snooping TCN Flooding. •
SWiTCh UPLiNkS
Turn off IP IGMP Immediate-Leave or Fast-Leave. •
BeST PraCTiCeS
Review IP IGMP Query and Election processes before configuring switches. •
Create a separate VLAN for all StreamNet devices. •
Create an ACL (Access Control List) that blocks IP IGMP on the switch port used to connect •
the StreamNet switches to a host network.
6224 - 6248 imPLemeNTaTiON