ClearOne StreamNet Infrastructure and Network - Manual (Page 15)

Chapter 2: Switch Configuration Settings 12
Chapter 2: Switch Configuration Settings
NeTSTreamS, CLearONe aNd deLL BraNded SWiTCheS
5424 - 5448 imPLemeNTaTiON
firmware and Boot Codes
SW version 2.0.0.36
Boot version 2.0.0.0
(Both Firmware and Boot Code can be requested from ClearOne Technical Support)
dell 5424 - 5448 Switch Settings
Create VLAN and set the Switch or VLAN IP Address (StreamNet devices should reside on •
same VLAN)
Set the “Bridge Multicast Unregistered-filtering” function to forbid Forwarding-Unregistered-
•
Multicast-Addresses.
Turn on IP IGMP v2 or v3 Querying, set the Query Interval, Snooping and set Interval and
•
Leave Time.
Turn off STP (Spanning Tree Protocol)
•
Turn on Multicast Filtering. •
Turn on Jumbo Frame Support (only needed with uncompressed streams). StreamNet stream •
packets are MTU 4096.
Configure Switchport Access for VLAN and Mode.
•
access Ports
Turn on IP IGMP Snooping. •
Turn on IP IGMP Immediate-Leave •
Turn off STP (Spanning Tree Protocol) •
Switch Uplinks •
Turn off IP IGMP Immediate-Leave •
Create an ACL (Access Control List) that blocks IP IGMP on the switch port used to connect •
the switches to a host network.
Best Practices
Review IP IGMP Query and Election processes before configuring switches. •
Create a separate VLAN for all StreamNet devices. •
Create an ACL (Access Control List) that blocks IP IGMP on the switch port used to connect •
the switches to a host network.