ClearOne NS-IPD-100 User Manual
Page 8
5 technical support: 800-283-5936
On the Device Panel, click on the
3.
Enable Static IP and enter the IP, Subnet Mask and Gateway addresses
of the interface device (TLA250 as shown in the Basic Connection diagram). Optionally, check the
Enable
DHCP checkbox if a DHCP server is to be used. If the DHCP is enabled and a DHCP server are not avail-
able, the TLA250 or the SL251 will revert to the Auto IP address settings in the Dealer Setup.
Click on the “
4.
apply” button in the lower-left of the Device Panel.