LaMotte WaterLink 3 Express Lab - Manual (Page 21)

SETTING UP THE WATERLINK® 3 EXPRESS
COLORIMETER
RUN PC LINK (UNAVAILABLE AT THIS TIME) 
The meter may be interfaced with any Windows-based computer by using
a program designed to receive the data when the Logging function is
enabled. The meter program will store test information and results in a data
base. To transfer data from the meter to a computer, plug the smaller end
of the USB cable (USB mini B connector) into the meter and the large end
of the USB cable (USB Type A connector) into a USB port on a computer.
The PC software program has to be designed to receive the test data when
in the Logging function is being used. Currently, the DataMate™ software
program does not have this ability to receive the data through the Logging
function.
ABSORBANCE 
The calibrations for the tests in each sequence have been factory set. The
absorbance mode is used by technicians during the manufacture of the
meter. It should not be necessary to access the absorbance mode during
normal operation of the WaterLink ® 3 Express.
SETTING THE CLOCK 
Setting the clock allows the correct time and date stamp to be stored with
each reading in the data logger.
Press 1. briefly to turn the meter on.
Press 2. to scroll to Setup.
Press 3.
ENTER
to select Setup. Press or to scroll to Set Clock.
Press 4.
ENTER
to select Set Clock. The date is displayed as month-day-
year. The time is displayed as hours: minutes: seconds AM/PM. Press
or to the appropriate character and press
ENTER
to select.
The cursor will move to the next character. Select all characters in the
same manner. This is a scrolling menu.
Press
5.
ENTER
to select the final character.
Press 6.
EXIT
to go back to the Main Menu or to turn meter off.
21
Setting up the W
aterLink
® 3 Express Colorimeter