LaMotte DO 6 Dissolved Oxygen Meter - Manual (Page 31)

7.3 (CAL.2) Calibration Data
You can view the latest
calibration data for the %
Saturation and the mg/L (ppm)
Concentration calibrations. The
calibration data from each mode
can be viewed in the Set Up
menu respectively.
7.3.1
Viewing the %
Saturation calibration dat
From the % Saturation or
Temperature Set Up menu,
1. Press the
p and q keys to
scroll through the main
group to enter the viewing
menu “CAL.2” for the latest
calibration data.
2. Press HOLD/ENTER key to
view the latest % Saturation
calibration data.
To exit to the main group
menu, press the
HOLD/ENTER key or the
CAL key
3. To exit to the main group
menu, press the HOLD/ENTER key or the CAL key.
4. Press the CAL key to return to the measurement mode.
7.3.2. Viewing the mg/L (ppm) Concentration calibration data
From the mg/L (ppm) Concentration Set Up mode,
1.. Repeat process 1 to 4 above to view the latest mg/L (ppm) Concentration
calibration data.
at steps 1-5 until all points have been calibrated.
7.4 (ELE.3) Electrode Properties
This menu features data of the electrode properties for diagnostic purposes.
The “view only” parameters such as the electrode Slope Factor, % Saturation
Offset setting, 100% Saturation mV value and 0% Saturation mV value are
30
10.00
8.24
CAL
CAL
Figure 22: Viewing the last calibration
data for each measurement range.
CAL.2
HOLD
ENTER
Display will show the latest % saturation
Calibration if set up menu is selected from the
DO%Saturation Mode
Display will show the latest mg/L or ppm
calibration if set up menu is selected from the
DO mg/L (ppm) Concentration Mode