Exide Technologies GB4128 - Manual (Page 3)

Ferro Magnetics Corporation, St. Louis, MO
SAFETY INSTRUCTIONS
WARNING
THIS EQUIPMENT CONTAINS LETHAL VOLTAGE LEVELS. INSTALLATION AND
SERVICING MUST BE PERFORMED BY QUALIFIED PERSONNEL
IMPORTANT: SAVE THESE INSTRUCTIONS!
READ AND FOLLOW ALL INSTRUCTIONS BEFORE INSTALLING, OPERATING, OR
SERVICING CHARGER. ANY DEVIATION CAN CAUSE SERIOUS AND PERMANENT
DAMAGE. FAILURE TO FOLLOW THE INSTRUCTIONS VOIDS THE WARRANTY.
1. Install and ground the charger in accordance with the National Electric Code and your local
electric code. Failure to properly ground the charger could result in a fatal electric shock.
2. To reduce the risk of fire, install chargers on a surface of non-combustible material, such as
concrete, stone, brick or grounded metal.
3. Connect only batteries of the same number of cells and ampere-hour rating as listed on the
charger nameplate. Damage to the battery could occur, particularly if the battery has fewer cells
than the rating of the charger.
4. Do not touch uninsulated parts of the output connector or battery terminals. A possibility of
serious electrical shock exists.
5. During charge, batteries produce hydrogen gas, which can explode if ignited. Never smoke, use
an open flame, or create sparks in the vicinity of the battery. Ventilate well when the battery is in
an enclosed space.
6. Do not connect or disconnect the battery plug while the charger is on. Doing so will cause
arching and burning of the connector resulting in charger damage or battery explosion.
7. Lead-acid batteries contain sulfuric acid, which is caustic and can cause chemical burns to the
skin. Refer to the battery manufacturers instructions for safe handling of batteries. Use proper
personnel protective equipment. Do not get in eyes, on skin, or on clothing. In cases of contact
with eyes, flush immediately with clean water for 15 minutes. Seek medical attention
immediately.
8. Do not operate the charger with the door open or with any panels removed. De-energize all AC
and DC power connections before servicing the charger.
9. The charger is not for outdoor use. Do not expose the charger to water spray, rain or snow.
10. Do not operate the charger with damaged cables, including cables with exposed conductors or
damaged connectors. Replace damaged cables before operation.
11. Do not operate the charger if it has been dropped, received a sharp blow, or otherwise damaged
in any way. Call your service representative.