Viking Pump TSM288: SL Series Lobe Pumps - Manual (Page 17)

4.03 4.04
fIGURE 34
4.01
fIGURE 35
fIGURE 36
4.08
4.04
fIGURE 37
3.01
7.03
fIGURE 38
4.07
3.01
fIGURE 39
2.02 / 2.03
2.01
fIGURE 40
1.04
3.01
SECTION TSM 288 ISSUE A PAGE 17 OF 36
4.1.9 GEaRbOX assEMblY
• Install the rear lip-seal (4.03) into the bearing housing cover
(4.04)
• Install the bearing housing O-ring (4.02) into the bearing
housing (4.01)
• Install the bearing housing cover (4.04) and the retaining
screws (4.08)
4.1.10 fINal assEMblY
NOTE: Before re-assembling the casing refer to the seal
section for assembly instructions.
• Install the guard (7.03) onto the rear of the casing (3.01)
• Install the casing (3.01) and secure with screws (4.07)
NOTE: For the SLF
• Install the rotors (2.01) and rotor retainer O-ring (2.03) and
secure with rotor retainers (2.02) (See section 6.2 for torque
settings)
• Install the head studs (1.04) into the casing (3.01)