Unitec Portal Console - Manual (Page 8)

P O R T A L T I
Document Number: PTL1005 4
3 Console Configuration Procedures
Now that the Console has been installed, you will need to configure it to communicate with
your Portal TI.
3.1 Requirements
In order to properly configure the Console, you will need the computer name of the Portal TI
Unit. The name is displayed in the Status box on the Portal Maintenance Screen.
3.2 Console Configuration Procedures
The following procedures should only be performed by qualified IT professionals.
1. With the Portal TI Unit connected to the network and powered on, power on the
Console.
Note:
The first time you boot up the Console after installing new software, the unit will run the
gray screen program, which performs a series of self-configuration procedures. DO
NOT INTERRUPT THESE PROCEDURES.
2. When the Console completes the boot process (when installing new software only),
the Console will display the following screen:
Figure 2. Red Connection Failed Screen
Document Title: Portal TI Console Installation and Operations Manual