Unitec Portal Console - Manual (Page 6)

P O R T A L T I
Document Number: PTL1005 2
2 Console Hardware Installation Procedures
Installation of the Console consists of connecting the Power Supply, the Receipt Printer, the
Card Reader, and then connecting the Console to the network router.
2.1 Requirements
The console requires the following items:
• LAN - The Console can only be used if you have the Portal connected to a Local
Area Network (LAN).
• Ethernet Cable – You must have sufficient Ethernet cable to reach from the
Console location to the LAN/Router (this length cannot exceed 294ft).
2.2 Installation Procedures
Refer to Figure 1 during installation for identification of the ports on the back panel of the unit.
Figure 1. Console Connection Locations
2.2.1 Console Installation Procedure
1. Connect the Ethernet cable to the Ethernet Port.
Document Title: Portal TI Console Installation and Operations Manual