Unitec C-Start Owner’s Manual - Manual (Page 14)

C - S T A R T
Document Number: CST1002 6
Document Title: C-Start Owner’s Manual
Page (described in section 3.3.7). Operating schedules can be configured to vary by day of the week. The
operating schedule is disabled by default.
3.3.3 Wash Dispensing
The wash dispensing page is used to assign and configure the wash packages that will be offered at the C-
Start. Wash packages must be set-up through the Products page (section 3.2) before they can be assigned
to a C-Start device profile. This feature will typically not be changed after installation, but there are some
features of a wash package that an owner may want to adjust including:

Added Services Offered – Allows one or more additional services to be offered to the purchaser of
the wash package. The Added Services to be offered can vary by package. An added service must
be added to the device profile (per section 3.3.4) before it can be assigned to a wash package.

Token Dispensing – When enabled, one or more tokens will be dispensed with each purchase (of
the wash package).

Wash Details Text – The wash details text is displayed under the Wash name inside the wash
selection button. Up to 7 lines of text (18 characters per line) can be added. The wash selection
button will be sized to fit the amount of text entered so the buttons can be made larger by
entering more lines of text.
3.3.4 Added Services Dispensing
The Added Services Dispensing page is used to select and configure the added services that will be offered
with one or more of the wash packages. Added services must be set-up through the Products page
(section 3.2) before they can be assigned to a C-Start device profile. An added service can be configured to
dispense one or more tokens when purchased. This feature allows an operator to sell token packages as
an added option to the wash purchase.
3.3.5 Wash Interface
The Wash Interface Set-up page is used to configure the hardware interface between the C-Start and the
wash controller. These settings should only be changed by your distributor.
3.3.6 Programming Hardware Devices
The Peripherals page is used to configure the various hardware devices in the C-Start such as enabling the
RFID and the bar code scanner. These settings would typically not be changed after installation.
3.3.7 User Interface Set-up
The User Interface set-up page is used to change messages displayed to customers and adjust ‘time-out’
values for certain user screens. There are several features on this page that an operator may wish to
adjust including: