Tweco 400 Ultra-Cut(May 2014) - Manual (Page 36)

ULTRA-CUT 100 XT/200 XT/300 XT/400 XT
3-12 INSTALLATION Manual 0-5302
3.12 Connect Cables for CNC, Remote Arc Starter, DMC-3000 and HE 400
1. Connect one end of each cable to the power supply.
2. Connect the other end of the CNC cable to the CNC device .
3. The CNC cable shield must be attached to ground at the CNC end.
USER INPUT
HEIGHT CONTROL
F1 - 8A SB 230 VAC F2 - 8A SB 230 VAC
CB4 - 5A 120 VAC
CB3 - 5A 24 VAC
CB2 - 5A 120 VAC
J55 - GCM
J15 - CNC
J59 - RAS
J70 - HE
J54 - TSC /COMM
Art # A-11994
J15 To CNC Control
J59 To Remote
Arc Starter
J55 To DMC-3000
J70 To Heat
Exchanger
J54 TSC/
Comm