Tweco PakMaster 75XL Plus User Manual
Operating manual, Air plasma cutting power supply
Table of contents
Document Outline
- SECTION 1: GENERAL INFORMATION
- 1.01 Notes, Cautions and Warnings
- 1.02 Important Safety Precautions
- 1.03 Publications
- 1.04 Note, Attention et Avertissement
- 1.05 Precautions De Securite Importantes
- 1.06 Documents De Reference
- 1.07 Declaration of Conformity
- 1.08 Statement of Warranty
- SECTION 2: INTRODUCTION
- 2.01 Scope of Manual
- 2.02 General Description of System
- 2.03 Specifications/Design Features
- 2.04 Power Supply Options and Accessories
- SECTION 3: INSTALLATION PROCEDURES
- 3.01 Introduction
- 3.02 Site Selection
- 3.03 Unpacking
- 3.04 Lifting Options
- 3.05 Input Power Connections
- 3.06 Input Voltage Selection
- 3.07 Primary Input Power Cable Connections
- 3.08 Gas Connections
- 3.09 Connecting Torch Leads
- 3.10 Work Cable And Ground Connections
- 3.11 Tip Saver/Drag Cut Sensing Circuit
- SECTION 4: OPERATION
- 4.01 Introduction
- 4.02 Functional Overview
- 4.03 Operating Controls
- 4.04 Sequence of Operation
- 4.05 Preparations for Operating
- 4.06 Cut Quality
- SECTION 5: CUSTOMER/OPERATOR SERVICE
- 5.01 Introduction
- 5.02 General Maintenance
- 5.03 Common Operating Problems
- 5.04 Troubleshooting Guide
- 5.05 Power Supply Parts Replacement
- SECTION 6: PARTS LISTS
- 6.01 Introduction
- 6.02 Ordering Information
- 6.03 Complete Power Supply Replacement
- 6.04 Replacement Parts
- 6.05 Options and Accessories
- APPENDIX I: INPUT WIRING REQUIREMENTS
- APPENDIX II: SEQUENCE OF OPERATION (BLOCK DIAGRAM)
- APPENDIX III: SYSTEM SCHEMATIC