SONIQ I402 - Manual (Page 18)

Chapter 7 Setup (3)
-18-
7.8 How to Set Alarm?
Note: Setting Alarm, make sure Clock time is set in advance.
1. Press ALARM 1 or ALARM 2, let’s take set alarm 1 as
example.
2. While cursor point to ‘ Alarm 1 Off’, press SELECT to
confirm, meanwhile, alarm states ‘off’ will be twinkling.
3. Turn SCROLL/SELECT to convert the states of alarm
1 from ‘ Off’ to ‘On’, press this knob to confirm, relative
alarm icon will be hopped on.
4. Now, follow your radio instruction, configure the following parameters:
Mode , iPod and Buzzer. N ote that if alarm comes, happened no
CD or iPod/iPhone insert in main unit, your radio would use buzzer instead.
Set days: Daily, Once, Weekend or Weekday
Volume: 01-30. Note that don’t set your radio volume level to zero (Mute),
otherwise, when alarm is coming, the alarm sound cannot be heard
Turn Alarm Off:
When alarm is coming, press either to deactivate it, or press SCROLL/SELECT to
activate SNOOZE function.
Note: If you press SCROLL/SELECT knob to cancel alarm, it should put radio into
SNOOZE status which you’ve set at page 16, after it reaches this postpone time, the alarm
will be sound again.
To cancel Alarm: You need set the states of alarm from ‘On’ to ‘Off’, refer to above
step1-3, turn SCROLL/SELECT to convert alarm states from ‘On’ to ‘Off’, press this
knob to confirm.
*
*
*
7.9 How to Get software version?
Note: The helpdesk may ask you for the radio info of your product, such as Radio sw version.
1. Press and hold MENU until it shows ‘Set EQ’, then turn SCROLL/SELECT to ‘ MCU version’.
2. Press SCROLL/SELECT knob to confirm, you will get the software version.
7.7 How to Factory Reset?
Note: This is an irrep
clock/alarm settings will be permanently erased.
1. Press and hold MENU until it shows ‘Set EQ’, and
then turn SCROLL/SELECT to ‘ Reset’.
2. Press SCROLL/SELECT knob to confirm.