Sindoh A610dn - Manual (Page 42)

Printer Installation
2-
20
8. Printer Setting Check
Turning on the printer
1 Connect the end of the power cord to the port on the back of the printer and plug the power cord to
the properly grounded wall outlet.
2 Switch on the printer.
When initial warming-up is complete, the message [Ready] will appear to indicate the printer is ready
to receive data.
If the message other than [Ready] appears, see
「 Understanding Printer Messages」 p. 3-15.
3 Check your PC and see if other devices are on.
4 Move on to the next step.
- Leaving the printer with power switched off for a long time may result in abnormal images.
Printing the System Report Page
Print the system report to see initial settings and check if options are properly installed.
1 Check if the printer is on.
2 Press the【◀】 or 【▶】 button until [Reports] appears.
Then, press the【OK】 button.
3 Press the【◀】 or 【▶】 button until [System Report] appears.
Then, press the【OK】 button.
4 If options are not displayed, switch off the device, unplug the power cord, and then install options again.
5 Check the tray and paper type.
Caution