Reloop TERMINAL MIX 4 - VirtualDJ 8 Operation Guide - Manual (Page 7)

VirtualDJ 8 – Reloop Terminal Mix 4 7
13. FX1 knob. Controls the 1
st
parameter of the selected effect of FX Slot 1. Hold SHIFT
down and use this knob to control the 2 nd parameter of the selected effect of FX Slot
1.
14. FX2 ON. Press this button to enable/disable the selected effect of FX Slot 2. Hold
SHIFT down and then press this button, to select the next available effect for FX Slot
2.
15. FX2 knob. Controls the 1 st parameter of the selected effect of FX Slot 2. Hold SHIFT
down and use this knob to control the 2
nd
parameter of the selected effect of FX Slot
2.
16. FX3 ON. Press this button to enable/disable the selected effect of FX Slot 3. Hold
SHIFT down and then press this button, to select the next available effect for FX Slot
3.
17. FX3 knob. Controls the 1 st parameter of the selected effect of FX Slot 3. Hold SHIFT
down and use this knob to control the 2 nd parameter of the selected effect of FX Slot
3.
18. .TAP. Press this button (for at least 4 times while track is playing) to manually tap the
tempo of the track
Hold SHIFT down and then press this button to set the TAP button and the BEATS
ENC (19) to Video mode (led will be On)
The Video mode is side/deck dependent (can be enabled/disabled on either side
separately).
In Video mode, use the button on the left side to trigger the selected Video
Transition, and the button on the right side to trigger the selected Video Effect on
Master.
19. BEATS ENC. Use the encoder to move the track forward or backwards by 1 beat.
Hold SHIFT down and then use this encoder to move the CBG of the track by 1 beat
forward or backwards.
If the Video mode is enabled, use the encoder on the left side to select a Video
Transition and the encoder on the right side to select a Video Effect on Master.
Hold SHIFT down and then use the same encoders to adjust the 1
st parameter (if
available) of the selected Video Transition or Video Effect on Master respectively.
.
C. LOOPS
20. LOOP SIZE. Turn the encoder anti-
clockwise to half the size of the loop
and clockwise to double it.
Push the encoder to trigger a loop
of the selected size.