Reloop TERMINAL MIX 4 - VirtualDJ 8 Operation Guide - Manual (Page 6)

VirtualDJ 8 – Reloop Terminal Mix 4 6
6. JOGWHEEL. Touch sensitive platter for scratching (vinyl mode), bending (CD Mode)
or fast Seek, depending on the selected mode.
In Scratch mode, use the jogwheel to scratch and the outer ring to bend (temporary
slowdown/speed-up tempo)
In Bend mode, use the jogwheel to temporary slowdown/speed-up the tempo of the
track.
In Seek mode, use the jogwheel to fast seek through the track.
7. JOG MODE. Use this button to toggle between the Scratch (Vinyl) and Bend (CD)
mode. Press and keep this button down to set the Jogwheel in Seek mode (as long as
the buttons is pressed)
8. PITCH. Controls the track's playback tempo. The blue led indicates that the pitch
fader of the unit is on zero (center) position
9. KEYLOCK. Press this button to enable/disable Master Tempo (Key Lock) on the
deck.
Hold SHIFT down and then press this button to enable/disable Pitch Lock. When
Pitch Lock is enabled the led of this button will blink and all the software pitch faders
will move to the same amount if any of the hardware pitch faders are moved.
10. RANGE. Press this button to select the next available pitch range. The pitch range
applies to all VirtualDJ decks (global setting).
Hold SHIFT down and then press this button to smoothly bring the tempo of the track
to its original value (reset)
11. OFFSET. This Led will be turned On if the hardware and the software values of the
pitch (tempo) don’t match. This may happen when decks are swapped (left and right)
or the SYNC is pressed. The hardware pitch slider will not alter the tempo of the track
until it meets the value of the software tempo.
.
B. EFFECTS
This section offers control of 3 Effect slots per
deck, Beatgrid adjustments, Master video
Effects and Video Transition controls.
12. FX1 ON. Press this button to
enable/disable the selected effect of FX
Slot 1. Hold SHIFT down and then
press this button, to select the next
available effect for FX Slot 1.