Reloop TERMINAL MIX 4 - VirtualDJ 8 Operation Guide - Manual (Page 11)

VirtualDJ 8 – Reloop Terminal Mix 4 11
48. INPUT ROUTING MIC. Select with this switcher if the Microphone Input will be directly
routed to the Master Output of the TM4 (MST position) or to the software mix (SW
position).
49. INPUT ROUTING PHONO/LINE. Select with this switcher if the Phone/Line Input
(connection at the rear side) will be directly routed to the Master Output of the TM4
(MST position) or to the software mix (SW position).
50. LINE LEVEL. Adjust the signal Level and the Tone of the Phone/Line Input. Hardware
operations (not visible on the VirtualDJ GUI), however the Line/Phono Input can be
routed into the software (see Recording)
51. CF ASSIGNS. Define which mixer channels (decks) will be assigned as left (A
position) or right (B position) side of the crossfader. If in a channel is at THRU
position, the channel will be heard in Master Output regardless of the Crossfader
position.
52. CF CURVE. Define how the crossfader will blend the mixer channels.(from Smooth to
Cut/Scratch curve)
53. HEADPHONES TONE. Adjust the tone of the Headphones Output Channel.
Hardware Operation, not visible on the GUI of VirtualDJ.
54. HEADPHONES PHONES INPUT. Connect a pair of Headphones to this socket (1/4 ”
or 1/8 ”). The Volume of this Output is controlled by the knob at the top panel
G. REAR
55. POWER: The unit can be powered only via the USB connection, however a Power
connection (using a proper AC/DC adaptor) is required to route the analogue inputs
directly to the Master Output (stand-alone operation). While the power is switched off,
plug the cable into TM4 first, and then plug the cable into a power outlet. Use the
Power Switch to turn the TM4 on and off. Turn on the TM4 after all input devices have
been connected and before you turn on amplifiers. Turn off amplifiers before you turn
off TM4.
56. USB. This USB connection sends and receives audio and control information from a
connected computer.
57. MASTER OUTPUT BALANCED (TRS): Connect this low-impedance TRS output to a
PA system or powered monitors. The level of this output is controlled with the Master